How to Remove Mold from a Wood Cutting Board

Introduction

Wood cutting boards are a great tool to have in the kitchen. They are sturdy, easy to clean and last a long time. Unfortunately, over time, they can develop mold or mildew. This can be caused by moisture and humidity in the kitchen, or from food residue left on the board. This can make them unsightly and unhygienic.

What You’ll Need

To remove mold and mildew from your wood cutting board, you’ll need a few simple items. You’ll need white vinegar, baking soda, coarse salt, and a scrub brush or cloth. You may also want to have a small bowl or bucket to hold the vinegar and salt mixture.

Cleaning the Board

Begin by mixing together equal parts of white vinegar and coarse salt in a bowl or bucket. The salt helps to scrub away the mold and mildew, while the vinegar helps to kill the spores. Once you have the mixture, use a scrub brush or cloth to apply it to the board. Rub it in a circular motion until it has been thoroughly applied. Let the mixture sit on the board for 15 to 20 minutes. This will allow the vinegar and salt to do their work.

Rinsing the Board

Once the mixture has had time to do its work, it’s time to rinse the board. Use warm water and a scrub brush or cloth to scrub away the mixture. Be sure to rinse thoroughly, as any vinegar or salt left on the board may damage the wood over time. Once the board is clean, pat it dry with a clean cloth.

Drying the Board

Once the board is dry, sprinkle it with baking soda. The baking soda helps to absorb any remaining moisture and also helps to whiten the wood. Let the baking soda sit for 15 minutes, then wipe it off with a damp cloth. Finally, let the board air dry for an hour before using it again.

Conclusion

Mold and mildew can be a problem on wood cutting boards. However, with a few simple ingredients and a bit of elbow grease, you can easily remove the mold and keep your board looking and smelling good. So the next time you find mold on your wood cutting board, don’t panic! Just grab some vinegar, salt, baking soda and a scrub brush, and you’ll have your board looking good as new in no time.